Thermoplastics for Orthotic and Prosthetic Devices and Components

Several material and technical expert industry leaders discussed thermoplastics used for O&P applications in the March 1020 O&P Business News ( http://www.oandpbiznews.com/201003/2.asp) .

While there is some need for O&P specific formulations (such as thinner and stronger) the economics of development makes it very difficult to attract suppliers because the O&P industry is so small. Plastic sheet goods have not been formulated specifically for O&P applications, and yet over the past couple decades O&P care providers have found a great deal of success using thermoplastics to fabricate devices and components.

Use of thermoplastics delivers many improvements, compared to traditional metal and leather systems, including:

  • Design options for increasing contact and support to the limb
  • Simple fabrication procedures
  • Weight reduction with retained strength
  • Cosmesis improvements with a variety of options to color or decorative heat transfers

Tamarack Habilitation Technologies, Inc. manufactures the world’s most widely used ankle joints. The Tamarack Flexure Joint family includes free motion joints and dorsi assist joints – all of which are interchangeable within each size range. This gives the orthotist many options when designing an AFO. These joints have very high tension load capacity – they do not stretch out or break, and are very simple to fabricate. The joints can be positioned to articulate the ankle joint in either line of progression or anatomical orientations. These joints are also useful for upper limb applications (elbow and wrist).

Tamarack also makes two other ankle joint models, specifically for thermoplastic fabrication;

  • The TVA, which is a model in the TFJ family made in two sizes – Adult and pediatric – that allows the orthotist (or a therapist) to adjust the level of dorsi assist moment with a simple hex driver while the patient is wearing the orthosis.
  • The Clevisphere joint, a stainless steel model that allows for rapid fabrication and the addition of being able to adjust and control plantar flexion (posterior stop). The joint is made using a unique clevis bearing that does not require the usual alignment procedures of overlap joints – each joint “co-aligns” to a common joint axis automatically. This makes fabrication very simple and joint operation very smooth and free.

See the entire range of joints, and the new Tamarack Flexure Joint Product Guide on our website: www.tamarackhti.com

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s